SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Easy to mount bolt on bobber signals?
/cgi-bin/YaBB.pl?num=1331817168

Message started by built2last66 on 03/15/12 at 06:12:48

Title: Easy to mount bolt on bobber signals?
Post by built2last66 on 03/15/12 at 06:12:48

I'm looking for some easy to bolt on thinner profile than stock turn signals, front and rear. I'm still riding a 2 seater, but I want thinner signals front and back.. anyone have any suggestions? I don't have alot of time at the moment for mods and I'm having a hard time finding anything good at my usual sources...I eventually plan on side mounted license plate and all that ruckus with a single springer seat, but for now these darn bullet turn signals are too bulky for me.. aha.. any links appreciated.. thanks! :D

Title: Re: Easy to mount bolt on bobber signals?
Post by arteacher on 03/15/12 at 06:27:37

Take the time and look in J&P cycles.

Title: Re: Easy to mount bolt on bobber signals?
Post by built2last66 on 03/15/12 at 06:38:19

272C2C252926273D3C480 wrote:

Take the time and look in J&P cycles.

I'm too paranoid to go to that site :o

Title: Re: Easy to mount bolt on bobber signals?
Post by thumperclone on 03/15/12 at 07:33:21

5E495550480E505D4F480A0A3C0 wrote:

[quote author=272C2C252926273D3C480 link=1331817168/0#1 date=1331818057]Take the time and look in J&P cycles.

I'm too paranoid to go to that site :o[/quote]

dont be skerd
cut up the plastic,lose the paypal password you're good to go ;)

Title: Re: Easy to mount bolt on bobber signals?
Post by spacepirates on 03/15/12 at 08:32:30

I bought these:
http://www.amazon.com/Motorcycle-Indicators-Blinkers-Cruisers-Davidsons/dp/B0057PX86Q/ref=sr_1_3?ie=UTF8&qid=1331825169&sr=8-3

...to replace three faulty turn signals on two other bikes. They work and look decent. Lower load than those stock signals were though, so they flash a bit faster. Not too hard to change with a resistor or a different flasher, plus they are cheap.

Amazon has some other turn signals that are even smaller (like these http://www.amazon.com/Small-Mini-Turn-Signals-Motorcycle/dp/B003UNPHMK/ref=sr_1_7?ie=UTF8&qid=1331825169&sr=8-7 which are about the size of a quarter) too.

I find that a lot of motorcycle-only websites jack up the price on parts that just don't seem like they should be worth that much, but i'm also just a cheap b*stard ;D

Title: Re: Easy to mount bolt on bobber signals?
Post by spacepirates on 03/15/12 at 08:37:15

for ease of installation, the first set I linked two bolts right on and wires right in (at least they did on my other bikes).

the second set (the small mini ones) just attach with double sided tape. can't get much easier than that.