SuzukiSavage.com /cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Fork bushing installation /cgi-bin/YaBB.pl?num=1329492109 Message started by beacon on 02/17/12 at 07:21:49

Title: Fork bushing installation Post by beacon on 02/17/12 at 07:21:49 I’m installing new fork oil seals and can’t figure out how to get the metal bushings ( #7, “metal slide” in the parts diagram) back down into place. I looked in the tech and “everything you need to know...” sections, but no answers. The bushings seem to be too big to fit and can’t be compresssed and forced in like the oil seal. How is this done so nothing gets damaged?

Title: Re: Fork bushing installation Post by MotoBuddha on 02/17/12 at 14:23:14 http://suzukisavage.com/cgi-bin/YaBB.pl?num=1300797103/15 You'll need something to drive them in with. Either a professional tool or a piece of PVC pipe.

SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved.