SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Warped swingarm?
/cgi-bin/YaBB.pl?num=1328295300

Message started by beacon on 02/03/12 at 10:54:59

Title: Warped swingarm?
Post by beacon on 02/03/12 at 10:54:59

Could someone with the rear wheel already off measure the distance between the inside surfaces of the plates where the axle goes through. Mine is about 238mm.
I had welding done on my swing arm and the welder said that the heat might have caused the thin metal to warp. He thinks the opening for the axle might have shifted.

Title: Re: Warped swingarm?
Post by justin_o_guy2 on 02/03/12 at 11:04:13

How does the wheel fit now?

Why didnt the welder put a spacer in it? Dilbert,,,,If he thot it could pull, he shoulda made sure it didnt,,

Title: Re: Warped swingarm?
Post by MotoBuddha on 02/03/12 at 11:08:53

This is why jigs were invented.