SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> 96' bucks to a new broom! /cgi-bin/YaBB.pl?num=1316664140 Message started by mr.HUBA on 09/21/11 at 21:02:20 |
Title: 96' bucks to a new broom! Post by mr.HUBA on 09/21/11 at 21:02:20 I was wondering if ill need to get diffirent cables for the switch? I dont like the bucks anymore and im looking for a cldaner straight bar look. Also, Ive been mulling over Z-Bars, but if I need to lengthen cBles ills stick to broomsticks haha. |
Title: Re: 96' bucks to a new broom! Post by Serowbot on 09/21/11 at 22:38:15 So long as you don't go to ridiculous... I think you can go broom or z... How wide on the brooms?... 34"?... How high on the z?... 6"?... I went to 32" drags on 4" risers... just fine... :-?... |
Title: Re: 96' bucks to a new broom! Post by mr.HUBA on 09/21/11 at 23:47:18 ahhh, im keeping the stock risers that come with my bucks. I wouldnt need to change anything if I pick up brooms right? and do the harley handlebars fit our bikes? those are mostly the ones on ebay |
Title: Re: 96' bucks to a new broom! Post by mr.HUBA on 09/21/11 at 23:55:06 ahh ok, i found a site that sells 1" diameter and 26" length bars for 90$! you can deff find em cheaper on ebay, but not chrome... I see alot of stainless steel ones, but would that look bunk with chrome risers and stuff? |
Title: Re: 96' bucks to a new broom! Post by mr.HUBA on 09/22/11 at 00:40:43 http://www.jpcycles.com/product/5000605 these would fit perfect I assume! they are 32" long and 1" thick |
Title: Re: 96' bucks to a new broom! Post by arteacher on 09/22/11 at 03:44:51 The knurling on our bikes is 4". so you would see the knurls. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |