SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Larger front fender. /cgi-bin/YaBB.pl?num=1311634089 Message started by arteacher on 07/25/11 at 15:48:09 |
Title: Larger front fender. Post by arteacher on 07/25/11 at 15:48:09 Does anyone have any suggestions for a larger front fender. I don't like the look of the stock fender,( I would like something more retro) and I want the front of the bike to have more protection from mud and dirt. Any ideas? |
Title: Re: Larger front fender. Post by CalisOsin on 07/25/11 at 16:06:33 If I recall WD's bike might have what you are looking for. I'd ask him. |
Title: Re: Larger front fender. Post by Boofer on 07/25/11 at 17:52:35 Or how about a mud flap? |
Title: Re: Larger front fender. Post by Paladin. on 07/25/11 at 18:14:06 Ask Max Morley: http://savage.andruschak.net/max_morley2.jpg |
Title: Re: Larger front fender. Post by mpnoffi on 07/25/11 at 19:08:34 I don't have a picture of my bike, but I am working on a high fender set up on my savage scrambler build. I plan to use my stock front fender after modifying it a bit. Here is the idea... http://i1181.photobucket.com/albums/x440/mpnoffi/108_0235.jpg This may not be what you are looking for...but I thought I would throw it out there...good luck! Mpnoffi |
Title: Re: Larger front fender. Post by Max_Morley on 07/25/11 at 19:20:51 I do have full fenders on both my Savages. Look in J&P cycles catalog for fenders that are not pre-drilled so you can drill the mounting points to fit your forks. !st one on the Yellow bike in the picture is their old number 13-200 which is off shore metal needs to have the HD holes welded shut and then new ones drilled. Also I had the back coated with that lumpy stuff so water would not work through as the seams between the sides and crown are riveted. 2n one on the sidear rig I got off CL from a gal in Tacoma but I', pretty sure it fits the same bikes is plastic and not pre-drilled. As it is plastic I have a fender brace on that one. The OE fender is reinforced so serve as a sorta fender brace. Application was DWG and others with about 5 1/2 " between the forks as I recall. I measured the distance and then went to non hostile HD guy and we measured HD forks until we knew which one was correct. I used some Alum plate to provide some extra support on the plastic one. Drop me an E-mail if you want a picture of the some what smaller plastic one. Put fender pic in subject so it doesn't get junked. Max |
Title: Re: Larger front fender. Post by Boofer on 07/25/11 at 23:28:16 I have to say, after reading that, Max is KING OF FENDERS! ;D |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |