SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Wiring For a Bobber /cgi-bin/YaBB.pl?num=1310333641 Message started by mike b on 07/10/11 at 14:34:01 |
Title: Wiring For a Bobber Post by mike b on 07/10/11 at 14:34:01 I'm buliding a bobber out of a 1986 Savage.The wiring is a mess.I'm looking for the most simple wiring set up for this bike.I'm not using any turn signals,horn,or handlebar controls.Just the bare minium,tail light,head light,start button,ignition switch,also will the bike run with all of the safety switches cut out if i'm still using the original electonics on the bike. |
Title: Re: Wiring For a Bobber Post by verslagen1 on 07/10/11 at 16:06:01 right here in our tect section... http://suzukisavage.com/cgi-bin/YaBB.pl?board=tech;action=display;num=1173898705 |
Title: Re: Wiring For a Bobber Post by mike b on 07/10/11 at 16:39:32 Do I have to use the ignitor,or can I eliminate it,or just use the leads for the pick up coil |
Title: Re: Wiring For a Bobber Post by verslagen1 on 07/10/11 at 16:41:53 yes no |
Title: Re: Wiring For a Bobber Post by dasch on 07/11/11 at 00:54:47 2B34272B2B29460 wrote:
?? The CDI? You have to use it. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |