|
SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Bleed holes or not? /cgi-bin/YaBB.pl?num=1306601606 Message started by arteacher on 05/28/11 at 09:53:26 |
|
Title: Bleed holes or not? Post by arteacher on 05/28/11 at 09:53:26 How much richer will bleed holes make the pilot circuit? |
|
Title: Re: Bleed holes or not? Post by Serowbot on 05/28/11 at 10:02:24 Measure the number of holes and the diameter of each,.. add them together,... divide by the inverse square of the tube circumference,.. and multiply by the jet size... If you end up with a letter instead of a number,... you did it wrong, just like me... :-?... I'd estimate,.. a bit.... say, a 52.5# becomes a 53#.... or nothing significant... I think it'd mostly supposed to smooth the delivery, more than make more flow....:-?... |
|
Title: Re: Bleed holes or not? Post by verslagen1 on 05/28/11 at 10:13:14 293F28352D38352E5A0 wrote:
http://smileyicons.net/s/529.gif |
|
Title: Re: Bleed holes or not? Post by Sunchasers on 06/02/11 at 12:10:33 As my parents would say... "It's that darn new math... you are on your own, sorry!" :o |
|
Title: Re: Bleed holes or not? Post by dasch on 06/03/11 at 11:11:49 3C2A3D20382D203B4F0 wrote:
Hey, I got a letter too!! In my case same size jet with bleeds vs. w/out cost me almost 2 full turns on mixture adjustment. Almost all turns I had at my disposal. I pulled it out, put the one w/out bleeds in and opened the screw 2 turns out. |
|
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |