SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> how to torque header bolt /cgi-bin/YaBB.pl?num=1306589775 Message started by Howitzer on 05/28/11 at 06:36:15 |
Title: how to torque header bolt Post by Howitzer on 05/28/11 at 06:36:15 How do you guys torque the header bolt at the engine block to spec? I can't fit my torque wrench in there, because the exhaust pipe is in the way. The pipe bends right around where my torque wrench would sit. I *could* just use a regular box wrench to tighten the bolts, but the bolts would be tightened to spec. |
Title: Re: how to torque header bolt Post by verslagen1 on 05/28/11 at 22:00:20 12" wiggly extension |
Title: Re: how to torque header bolt Post by Howitzer on 05/29/11 at 21:08:40 Doh. I can't believe I didn't think to try that. Actually, the 6inch extension worked for me, with a 3/8" drive socket wrench. |
Title: Re: how to torque header bolt Post by Mr. Hyde on 05/31/11 at 07:25:56 In the Clymer manual on page 208 #10, Tighten the exhaust pipe clamp bolts to 13-20 ft lbs. Does anyone interpret that to mean the exhaust header bolts, or the muffler to header pipe clamp bolt(s). |
Title: Re: how to torque header bolt Post by Routy on 06/01/11 at 12:00:45 76491573425F5E3B0 wrote:
Well, if I had to guess, I'd say because it says "exhaust pipe clamp", it would not mean the "muffler clamp". I know,.......there I go w/ my logical thinking again ! |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |