SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Spacer Mod/Air Mixture Screw? /cgi-bin/YaBB.pl?num=1306135178 Message started by Wake51 on 05/23/11 at 00:19:38 |
Title: Spacer Mod/Air Mixture Screw? Post by Wake51 on 05/23/11 at 00:19:38 I installed my new Dyna muffler today. As such, I also tuned the carb. I dropped in a 152.5 main jet but didn't have the other jets I needed to complete the job. (Probably need 52.5 pilot with bleed holes, unsure of the needle jet) Well in order to get the low end as close as possible, I looked to do the spacer mod and adjust the air mixture screw everyone mentions. Only problem is, I couldn't for the life of me find this 'spacer' everyone speaks of. I followed the guide in the tech forum but never found it... idk if I was looking in the wrong place or if perhaps the last owner took it out and I just think I'm not finding it. Couldn't even find mention of it in the manual. Would anyone have a picture of what I am looking for? I also have no idea where the air mixture screw everyone mentions is located. Again, pics? I'm a very visual learner. Sorry if I come off as a 'special' wrencher, my first time ever really breaking into something mechanically on this bike other than changing oil and brake pads. Thanks! -Wake |
Title: Re: Spacer Mod/Air Mixture Screw? Post by OE on 05/23/11 at 06:46:38 FIrst, go to the main page of this forum. From there select the "Technical Documents/Reference" section then select "Table of Contents with Links." Scroll down to "Carbs and Jetting" and you'll find all the pictures you need. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |