SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> ryca builders a little help?
/cgi-bin/YaBB.pl?num=1306005775

Message started by RpNSht on 05/21/11 at 12:22:55

Title: ryca builders a little help?
Post by RpNSht on 05/21/11 at 12:22:55

while dismantling my headlight and starter switch housing units i took photos of the insides to use as reference when re-assembling them. turns out i accidentally deleted these images. so im asking for some help from my fellow ryca builders. anyone out there mind posting a few photos of the guts of the switch housing units so i can see how the springs, screws, and switches line up? im afraid without photos ill be puzzled for a long long time. ugh

thanks in advance for the help! its truly appreciated

http://i1226.photobucket.com/albums/ee419/rpnsht/IMG_1691.jpg

http://suzukisavage.com/cgi-bin/YaBB.pl?num=1304297812

Title: Re: ryca builders a little help?
Post by Gyrobob on 05/22/11 at 14:36:16

RpNsht,

Here are 35 pics on photobucket:

http://s258.photobucket.com/albums/hh253/Gyrobob_theOriginal/Motorcycle/Savage%20LS650%20Switch%20Detail/

Looks like the switchery on the 2002 LS650 I bought for the Dual RYCA Build has not been apart in maybe a decade -- dust, dirt, spider webs, little dead bugs. It all worked fine before I took it apart, though, eh?

Some sample pics from the photobucket page:

http://i258.photobucket.com/albums/hh253/Gyrobob_theOriginal/Motorcycle/Savage%20LS650%20Switch%20Detail/Savageswitchdetail8irfan.jpg

http://i258.photobucket.com/albums/hh253/Gyrobob_theOriginal/Motorcycle/Savage%20LS650%20Switch%20Detail/Savageswitchdetail15irfan.jpg

http://i258.photobucket.com/albums/hh253/Gyrobob_theOriginal/Motorcycle/Savage%20LS650%20Switch%20Detail/Savageswitchdetail21irfan.jpg

http://i258.photobucket.com/albums/hh253/Gyrobob_theOriginal/Motorcycle/Savage%20LS650%20Switch%20Detail/Savageswitchdetail33irfan.jpg

Here's a tip,... Use a magnetized screwdriver for the little screws used to reassemble the switches, for two reasons:

1. It is a lot easier to get those $&^#ing little screws back in those *@#^ing little holes while you hold everything in alignment.

2. You won't lose as many little screws. >:(
http://i258.photobucket.com/albums/hh253/Gyrobob_theOriginal/Motorcycle/Savage%20LS650%20Switch%20Detail/Magnetizedscrewdriver01.jpg

Title: Re: ryca builders a little help?
Post by justin_o_guy2 on 05/22/11 at 23:30:58

Sweep the floor first, so IF anything hits the floor, it wont hide in a dustpan load of junk & toss some rags down, so stuff cant run across the floor for 10 feet.