SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> brake light not working /cgi-bin/YaBB.pl?num=1305994042 Message started by Latimer on 05/21/11 at 09:07:22 |
Title: brake light not working Post by Latimer on 05/21/11 at 09:07:22 My brake light isnt working when I hit the foot brake. It works just fine when I use the hand brake. I pulled off my pipe to take a better look at the cabling to see if something was disconnected and found the cabling going back to the light as seen in the picture. http://i54.tinypic.com/fohjlh.gif Is that right? Or does it need to be connected into something? If I follow the cable back to the middle of the bike I can pull on cable and the brake light will go off just fine. Is this just somehow disconnected? The clymers wasnt very helpful and I cant find any spot to slide that cable in on the foot brake mechanism. Any help would be very appreciated! |
Title: Re: brake light not working Post by verslagen1 on 05/21/11 at 09:16:27 real micky mouse set up. should be a tab for it on the end of the pin for the brake cable. I can see the plastic retainer is gone. just wire the two together. |
Title: Re: brake light not working Post by Latimer on 05/21/11 at 10:17:56 ahh the cotter pin and pivot pin. That must have been what clymers manual was talking about. THanks. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |