SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Re-jet without removing carb. /cgi-bin/YaBB.pl?num=1304263390 Message started by arteacher on 05/01/11 at 08:23:10 |
Title: Re-jet without removing carb. Post by arteacher on 05/01/11 at 08:23:10 Somewhere a while ago I saw a response to a thread about re-jetting without removing the carb by turning it on its side. I can't find it now. :-/ |
Title: Re: Re-jet without removing carb. Post by bill67 on 05/01/11 at 08:28:45 You don't have to turn it on its side,Just drop the fuel bowl and look up there and you can take them out. |
Title: Re: Re-jet without removing carb. Post by arteacher on 05/01/11 at 08:34:42 What about loosening the screws? This will be the first time and I imagine I will need to use an impact tool to loosen them- kind of hard to do with the carb in place? |
Title: Re: Re-jet without removing carb. Post by bill67 on 05/01/11 at 08:38:47 Get a good screwdriver and pretend your lifting the bike and turn it,You can also use a vise gripes to loosen them. |
Title: Re: Re-jet without removing carb. Post by verslagen1 on 05/01/11 at 08:40:47 do not use an impact driver on unsupported tabs, you'll break them off. +1 bill |
Title: Re: Re-jet without removing carb. Post by arteacher on 05/01/11 at 08:41:29 I will try that. Thanks. |
Title: Re: Re-jet without removing carb. Post by Serowbot on 05/01/11 at 09:00:50 ... and then replace them with allenheads... then, next time it's easy as toast... ;)... |
Title: Re: Re-jet without removing carb. Post by justin_o_guy2 on 05/01/11 at 10:16:00 If that carb hasnt been apart, Id put it on a bench. |
Title: Re: Re-jet without removing carb. Post by Reelthing on 05/02/11 at 08:28:16 Cover the starter with a rag else the washer that goes under the mainjet has a real good chance to end up there |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |