SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Need help separating... /cgi-bin/YaBB.pl?num=1304114045 Message started by Edgar on 04/29/11 at 14:54:03 |
Title: Need help separating... Post by Edgar on 04/29/11 at 14:54:03 The header pipe from the muffler. Don't want to damage the header pipe so I'm asking before going further http://i986.photobucket.com/albums/ae342/poosy_bucket/1f63ccdc.jpg |
Title: Re: Need help separating... Post by BuckHMCC on 04/29/11 at 15:10:13 What worked for me was repeated applications of PB Blaster into the joint over several days and repeated and careful tappings with a plastic-faced hammer. Soak that joint in PB Blaster, but don't do it inside as it has quite an odor. |
Title: Re: Need help separating... Post by verslagen1 on 04/29/11 at 15:45:27 Throw a couple pieces of wood on the ground to support and prevent scratches. You might want to make a cradle for the header, just round it a bit to match the pipe. Lay it down and step on joint. Rotate and repeat. |
Title: Re: Need help separating... Post by topgunz1 on 04/29/11 at 17:22:09 Glad I'm not the only one that had this issue. What worked for me was repeated banging of the entire assembly on the ground... Good thing about a project bike is you don't have to be gentle with the parts your getting rid of! |
Title: Re: Need help separating... Post by justin_o_guy2 on 04/29/11 at 19:09:25 Id get that clamp all the way off. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |