SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Drive pulley seal replacement /cgi-bin/YaBB.pl?num=1298391021 Message started by jdgronemeyer1s on 02/22/11 at 08:10:21 |
Title: Drive pulley seal replacement Post by jdgronemeyer1s on 02/22/11 at 08:10:21 I need to replace my drive pulley seal on my 1996 Savage. I have the pulley and metal seal cover off, but I can't seem to figure out how the seal comes off. Is there a trick to removing the seal? |
Title: Re: Drive pulley seal replacement Post by Serowbot on 02/22/11 at 11:34:49 5B5556435E5F545C544854430042310 wrote:
I doubt it... :-?... BUMP... |
Title: Re: Drive pulley seal replacement Post by justin_o_guy2 on 02/22/11 at 18:35:44 IDK if it installs from the inside or outside,, IF itll pull, at all, thn one eay answer is to drill a small hole in the seal main body & run a Dent Puller in it & rip it out Mite need more than 1 hole, |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |