SuzukiSavage.com /cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Cone Filter set up /cgi-bin/YaBB.pl?num=1294266631 Message started by ocdave on 01/05/11 at 14:30:30

Title: Cone Filter set up Post by ocdave on 01/05/11 at 14:30:30 I picked up a K&N cone filter that I plan on installing on my project Savage. From reading some prior threads I have seen a few cone filters set up with a PVC extension. Is this purely cosmetic? Is there any increased performance that can be gained by extending the filter away from the carb, perhaps in a different direction?

Title: Re: Cone Filter set up Post by verslagen1 on 01/05/11 at 14:38:24 You want to have an extention as long as the rubber duct between the carb and airbox.  This will allow the flow to stabilize before entering the throat of the carb.  It will improve low rpm response.  If you want a shorter duct you will need to add a flow straightener.  See Diamond Jim's turbulator.   8-)

SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved.