SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Need some measurements please
/cgi-bin/YaBB.pl?num=1290921818

Message started by smokin_blue on 11/27/10 at 21:23:38

Title: Need some measurements please
Post by smokin_blue on 11/27/10 at 21:23:38

I sold my stock front rim a couple of years ago so I am hoping someone can help me out. I am in need of 3 measurements on a front stock brake rotor.

1. outside diameter of rotor
2. inside diamter of rotor
3. bolt circle diamter (that would be the distance across from one mounting hole to the other opposite it)

Thanks!!
Smokin_blue

Title: Re: Need some measurements please
Post by justin_o_guy2 on 11/27/10 at 21:32:12

Buy a used disk & measure it out..?

Title: Re: Need some measurements please
Post by verslagen1 on 11/27/10 at 21:47:57

10.25" OD
3 7/16" ID
4.25" B.C.

Roughly, I can measure it more accurately if you want.

Title: Re: Need some measurements please
Post by markbacon on 11/29/10 at 15:20:44

I have a dxf file that I did to get a new disk cut, but can't get it to upload.

I got the dimensions you're after from an online PDF Goldfren catalogue, which listed them in mm as:

204-001F
SIDE
O.D. 260.3mm
H.D. 107.8mm
I.D. 87.3mm
THK. 4.7mm

The DXF I drew based on these worked perfectly for getting a replacement disk made.

Use 10mm as diameter for bolt holes, and plan to re-use the standard bolts - they've got an 8mm thread but a 10mm shank to fit sockets in hub.

Title: Re: Need some measurements please
Post by smokin_blue on 12/02/10 at 11:46:41

Thanks guys! the dims were great. showed me the disc wouldn't mod out for where I wanted to put it.

Title: Re: Need some measurements please
Post by smokin_blue on 12/07/10 at 05:58:11

that is a great catalog! it is a searchable PDF so you can find the specs for your disc and then see if any others have say the same ID or Bolt hole size....

thanks a bunch!