SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Right Hand Control Wiring Question
/cgi-bin/YaBB.pl?num=1286235538

Message started by dvansyck on 10/04/10 at 16:38:58

Title: Right Hand Control Wiring Question
Post by dvansyck on 10/04/10 at 16:38:58

Hello all,

I am almost done with the bike. It is a 2000 and it came with no right hand controls. I obtained one locally for a 2006 and I need some help. I have a Clymers manual but it only goes up to 2004. I have figured out most of the wiring but am stuck with a couple of wire connections. I was wondering if anyone has the answers to the following wires. I want to get this going but don't want to cross wires. I would appreciate the help.

Thanks,

Starter Switch
White Orange/White of kill switch
Yellow/white ????
Yellow/Green (eventually) to starter relay
Orange/Red ????

Engine Stop
Orange/White White to Starter Switch and ????
Orange/Black Sidestand relay

Front Brake
Black/Blue Rear Brake Light
Black/Red Power

Hazard Switch
Light Blue Don’t Care
Light Green Don’t Care
Black Don’t Care

Title: Re: Right Hand Control Wiring Question
Post by thumperclone on 10/04/10 at 17:47:16

the ssm shows one wiring diagram for years 96 >03
will re post as i decipher 04,05

if i read you rite you have new harness(hazard sw)
with old handle bar controlls (no haz sw)????
do you have 2 wire or 4 wire starter sw??(05 revision)

Title: Re: Right Hand Control Wiring Question
Post by dvansyck on 10/04/10 at 17:52:50

7E627F677A6F78696665646F0A0 wrote:

the ssm shows one wiring diagram for years 96 >03
will re post as i decipher 04,05

if i read you rite you have new harness(hazard sw)
with old handle bar controlls (no haz sw)????

I have a new (2006) RH control switch with 4 wire starter switch trying to connect to the original (2000) wire harness. The hazard wiring is of no concern currently, just wanting to get the starter switch and kill hooked up. I have the front brake light switch working. Just not sure about the wires stated.

Thanks,
DV

Title: Re: Right Hand Control Wiring Question
Post by thumperclone on 10/04/10 at 17:56:46

okay

processing

Title: Re: Right Hand Control Wiring Question
Post by thumperclone on 10/04/10 at 18:05:39

engine stop sw O/B(from ss relay) &
O/W (to ignitor) which also connects to starter sw along with Y/G(back thru safety ckt @ clutch lever sw)
now you have two wires left over from start sw think those kill the head lamp in 05 for more starting current
cap them off

Title: Re: Right Hand Control Wiring Question
Post by dvansyck on 10/05/10 at 05:34:33

6E726F776A7F68797675747F1A0 wrote:

OK, will try that tonight. Appreciate the help. Will let you know what I found.

DV