SuzukiSavage.com /cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> need help retrofitting levers /cgi-bin/YaBB.pl?num=1283497794 Message started by chuck farley on 09/03/10 at 00:09:53

Title: need help retrofitting levers Post by chuck farley on 09/03/10 at 00:09:53 Hey everyone.  I posted this in tech but was suggested I post here. This is my first bike and and don't know much. I  got some kuryakyn zombie levers only made for honda shadow.  Also got a shadow's clutch perch and brake resevoir. The brake resevoir is the same size and should go on with no problem. The clutch perch doesn't have the clutch safety switch box on the bottom like my savage. It looks like it has a cylinder shaped internal on that two wires connect to. So I was wondering if I could just buy a shadow's left switch assembly and cut the connector from my old one. Then cut the connector on the new one.  Put the old connenctor on the new switch assembly and wire them all manually like the horn,lights and turn signals. Then plug her in to the stock connector on the bike.  Is this possible? any suggestions?

SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved.