SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> engine specs!! need fast!! /cgi-bin/YaBB.pl?num=1277937502 Message started by fexterz11 on 06/30/10 at 15:38:22 |
Title: engine specs!! need fast!! Post by fexterz11 on 06/30/10 at 15:38:22 Hello guys, i bought the top end and cylinder and i am almost done with the rebuild process but i need to know some very important specs. 1) what is the clearance of the camshaft with the plastic (i dont want to torque it to much) 2) what is the torque in the head bolts 3) i need this by tonight! if anyone know them please call me at 909-767-6905 and leave me a message if i dont pick up or simply reply through the board.. thanks!! :D |
Title: Re: engine specs!! need fast!! Post by fexterz11 on 06/30/10 at 16:14:12 found the valve clearance which are a 0.008 to 0.013mm (.003 - .005 in inches) |
Title: Re: engine specs!! need fast!! Post by james may on 06/30/10 at 16:48:10 4 x 9mm nuts on the top of the cylinder head are 21-24ft-lbs 2x 8mm nuts on front and back on cylinder are 16-19ft-lbs according to the clymer manual. |
Title: Re: engine specs!! need fast!! Post by Serowbot on 06/30/10 at 17:00:57 747474747D73450 wrote:
Clymers millimeter conversion is wrong.... should be... 0.076 - 0.127mm (.003 - .005 in inches) |
Title: Re: engine specs!! need fast!! Post by verslagen1 on 06/30/10 at 17:08:58 cam clearance... http://suzukisavage.com/cgi-bin/YaBB.pl?num=1268452150 |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |