SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> turn signals /cgi-bin/YaBB.pl?num=1277828850 Message started by Bubba on 06/29/10 at 09:27:30 |
Title: turn signals Post by Bubba on 06/29/10 at 09:27:30 dumb question...I noticed my right front turn signal is burned out...only turns on when I use the signal so I guess the running light is out. Ayway, I then noticed the back turn signals weren't on either...do they have running lights or are they just on when you signal??? any idea what bulbs go in these??? Thx |
Title: Re: turn signals Post by EJID on 06/29/10 at 09:32:07 On stock signals, the front are running/turn lights and the rear are only turn lights, so you're rear signals sound fine but I'd be for changing the front one's bulb. 8-) |
Title: Re: turn signals Post by Bubba on 06/29/10 at 09:37:33 Thanks! |
Title: Re: turn signals Post by spacepirates on 06/29/10 at 10:33:28 no clue what bulbs go in 'em. i took my bike to an autozone, popped out the light, took it in and found one that looked like it. works just fine... i think i remember the guy at autozone saying something about the one i got having a higher wattage and that it might melt the casing, but i haven't had any issues so far. |
Title: Re: turn signals Post by Bubba on 06/29/10 at 11:25:37 Just did the same at Pepboys...no clue if the wattage is the same but it works! |
Title: Re: turn signals Post by justin_o_guy2 on 06/29/10 at 13:40:46 1156 is a single filament 1157 is a dual fillament |
Title: Re: turn signals Post by Oldnewguy on 07/01/10 at 13:13:32 yeh, and you will need sticky fingers to replace them. :) |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |