SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Clutch question - wave washer /cgi-bin/YaBB.pl?num=1277414794 Message started by BurnPgh on 06/24/10 at 14:26:33 |
Title: Clutch question - wave washer Post by BurnPgh on 06/24/10 at 14:26:33 Clymers says to install it with the concave side facing outward but in Chapter 5 Fig. 43 It shows that the "proper" way to install it is with the concave side facing inward. Which is it? |
Title: Re: Clutch question - wave washer Post by verslagen1 on 06/25/10 at 12:01:32 Is it 2may-to or 2mat-to? If I recall correctly... and I wish I could give you a picture... There's a machined inside diameter and a machined outside diameter with a ledge immediately adjacent. The corner of the wave washer should nest in each one. Otherwise the corner would be locking the movable ledge against the fixed diameter. |
Title: Re: Clutch question - wave washer Post by BurnPgh on 06/25/10 at 12:36:19 I took a chance and went by the picture in fig 43 and it worked beautifully. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |