SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> rejetting for dyna?
/cgi-bin/YaBB.pl?num=1270590935

Message started by RTC on 04/06/10 at 14:55:35

Title: rejetting for dyna?
Post by RTC on 04/06/10 at 14:55:35

I recently installed a dyna muffler and went to mess with the air mix screw for the first time. I turned it in until it bottomed out, counted the turns, and began to turn it out. I turned it out for almost 5 turns without noticing much loss in engine power, got a little concerned and set it to about 2.5 turns out where the engine sounded the strongest. do i need to rejet and what size? 155 main?

Title: Re: rejetting for dyna?
Post by prechermike on 04/06/10 at 15:26:57

This is just my experience. I put on a dyna muffler and adjusted the air screw mix and that was that. I do not remember how many turns I made, but I did not rejet. But that is just my experience.

I have read on here many times that every bike is different and I believe it, I am close to sea level, near the coast. For what its worth!