|
SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> WHERE THE HELL /cgi-bin/YaBB.pl?num=1269597593 Message started by jlsmedic on 03/26/10 at 02:59:53 |
|
Title: WHERE THE HELL Post by jlsmedic on 03/26/10 at 02:59:53 OKAY anybody got a quick answer for where the INFAMOUS white spacer is? Ive got the carb apart pulled the main jet, the other jet, the spring in side out and still haven't found the darn white spacer???? Hmmmmm starting to wonder if im lost.... just a little scared and still wondering... |
|
Title: Re: WHERE THE HELL Post by dasch on 03/26/10 at 03:20:04 Look into the slide (big plunger with needle attached to it), in the hole where the big spring was. You will see a butterfly looking piece of metal with two small screws. Under that thingy. Needle runs through it. |
|
Title: Re: WHERE THE HELL Post by jlsmedic on 03/26/10 at 03:35:15 Okay im trying like hell not to sound like the kid with a helmet on a short bus......butt...... the cover with 3 screws and the BIG spring on the side of the carb.... that has a plunger and a black diaphram/// underneath that is nothing??? Under the float with the little pointy thing.... theres nothing under there? the only thing I've found is a small washer with slits cut into the side... is that the correct washer? I dont want to shave down the incorrect part... |
|
Title: Re: WHERE THE HELL Post by dasch on 03/26/10 at 03:54:37 :) I could swear it's the big cover on the TOP (not the side) with FOUR (not three) screws hodling it in place. when you remove it, there's a FOOT long spring. Take it out. Stick your finger into the hole, there's an INCH wide grey slide (plunger) with 2 inches (not little) long needle attached to it. Slide the plunger out somehow. Now, look into the plunger, where the spring was. There's a weird shaped metal piece (with slits) held down by two screws. It has a hole in the middle with needle end sticking out. Unscrew screws. They are easy to strip, be careful. Push hard, turn lightly. Under it is the white washer. |
|
Title: Re: WHERE THE HELL Post by jlsmedic on 03/26/10 at 04:35:31 ooohhh on the top..... why didnt you say so.....lol |
|
Title: Re: WHERE THE HELL Post by Routy on 03/26/10 at 04:52:27 I did the same thing,.....but I could have known the tank had to come off. Again, be carefull you don't strip them little screw heads. Tho not easy, I used an impact driver on them. |
|
Title: Re: WHERE THE HELL Post by Serowbot on 03/26/10 at 07:27:57 Number 6... reduce the thickness by one third,... or buy a number #4 nylon washer at Ace Hardware (perfect fit and thickness).... ;)... http://personal.inet.fi/cool/alppu/bike/wt_2081.jpg |
|
Title: Re: WHERE THE HELL Post by dasch on 03/26/10 at 07:53:41 66607F616968656F0C0 wrote:
Hahaha, that's the spirit. Don't have to remove the tank. Just loosen it on that end and turn the carb to one side |
|
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |