SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> float hieght? /cgi-bin/YaBB.pl?num=1267765557 Message started by seabeast77 on 03/04/10 at 21:05:57 |
Title: float hieght? Post by seabeast77 on 03/04/10 at 21:05:57 does anyone know the best float hieght for 1995 savage? and what is the easiest way to adjust and measure it? thanks for the info guys. |
Title: Re: float hieght? Post by verslagen1 on 03/04/10 at 21:36:37 take a clear hose run it from the bottom of the carb up along the side and open the drain valve gas should come up a bit now turn the petcock to prime gas should come up to the gasket on the bowl |
Title: Re: float hieght? Post by jabman on 03/05/10 at 02:55:13 cool i need to do this where do you fit the tube? i cannot find any hole |
Title: Re: float hieght? Post by justin_o_guy2 on 03/05/10 at 03:31:27 bottom of the bowl, little hang down with a screw poked in the side. |
Title: Re: float hieght? Post by Reelthing on 03/05/10 at 10:18:08 if that '95 is like mine it doesn't have a drain other than to remove the entire screw on the bottom - no place for the hose unlike the '02 where the bottom of the bowl has a molded metal tube and the drain screw is on the side of this - that allows you put a clear tube on it on the '95 you'll just have to pull the bowl to set it - do have reason to believe it is off? Sort of a pain to do without pulling the carb - Float level as measured by the book method: 26.95-28.95mm (1.06-1.114in) |
Title: Re: float hieght? Post by jabman on 03/05/10 at 11:14:24 same here could you poke a hose up the drain screw and use that |
Title: Re: float hieght? Post by seabeast77 on 03/08/10 at 13:24:49 i'm sure it is off a little i just replaced it and it is running rich. and i even had a little gas come out of the overflows on the carb. |
Title: Re: float hieght? Post by jabman on 03/08/10 at 13:32:14 im sure mine is too low hence weird large jets |
Title: Re: float hieght? Post by Phelonius on 03/08/10 at 18:13:57 While the bowl is off, mo betta you swap out the four screws for stainless allens. They won't grow roots the way the factory anodized ones do. Phelonius |
Title: Re: float hieght? Post by jabman on 03/08/10 at 23:52:01 5A626F666564637F790A0 wrote:
+1 :) |
Title: Re: float hieght? Post by seabeast77 on 03/15/10 at 13:10:59 thanks for all the help guys. i have adjusted it but it seems like it may be a little to low now. oh well i will try it one more time .if it is not the float then i am perplexed. because now it is not starting easily like it hase no fuel and the idle is uneven. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |