SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Drive pulley nut /cgi-bin/YaBB.pl?num=1267277459 Message started by s40newbie on 02/27/10 at 05:30:58 |
Title: Drive pulley nut Post by s40newbie on 02/27/10 at 05:30:58 Could anyone tell me what size socket i need to take off the front drive pulley nut please? I think its 32mm but it doesnt say anything in the manual |
Title: Re: Drive pulley nut Post by Reelthing on 02/27/10 at 05:57:22 32mm it is |
Title: Re: Drive pulley nut Post by s40newbie on 02/27/10 at 06:07:45 Thanks :) |
Title: Re: Drive pulley nut Post by Phelonius on 02/27/10 at 09:56:18 There is also an american size that fits. I cant remember what it is. One of you math geniuses can probably figure it . Phelonius |
Title: Re: Drive pulley nut Post by Serowbot on 02/27/10 at 09:58:56 1 1/4"...? :-? |
Title: Re: Drive pulley nut Post by RidgeRunner13 on 02/27/10 at 10:28:06 32mm = 1.2598..........inches 8-) |
Title: Re: Drive pulley nut Post by Serowbot on 02/27/10 at 10:36:06 704B46454770574C4C47501311220 wrote:
1 1/4" n' a bit?... :-? 1 1/4" n' a hammer?... :-? |
Title: Re: Drive pulley nut Post by Toymaker on 02/27/10 at 10:56:32 I use a 32 mm and my impact gun.... :) |
Title: Re: Drive pulley nut Post by s40newbie on 02/28/10 at 04:57:22 Cool need to pick one up as they dont come as standard in socket sets which is a bit of a bummer :( |
Title: Re: Drive pulley nut Post by justin_o_guy2 on 02/28/10 at 11:32:54 The 1/2 deep impact set from Harbor Freight hass it. Around $18.00 IIRC |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |