SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Front brake light wires
/cgi-bin/YaBB.pl?num=1264356766

Message started by Stones on 01/24/10 at 10:12:46

Title: Front brake light wires
Post by Stones on 01/24/10 at 10:12:46

The two wires from the handlebar switchgear that connect to the bottom of the master cylinder switch have decided to fall off ::)

Ive unscrewed the plate etc looks too fiddly for me lol

Theres very little wire to play with any ideas or pattern replacements ?

Ok so im dumb ;D

Title: Re: Front brake light wires
Post by prechermike on 01/24/10 at 12:29:56

When I got my bike, I had a similar problem. Had to replace the doodad that slides inside the brake handle to activate the light. Then one of the wires broke off.

You can fix it, but do not use too much solder on it, both those contacts are close together and a little solder goes a long way. Just take your time and it is more tedious than anything else.

I was dumb, I looked at it and said, "No problem." Well, it was, not too much but that is fine work there.