SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Electrical connector /cgi-bin/YaBB.pl?num=1263598450 Message started by LANCER on 01/15/10 at 15:34:10 |
Title: Electrical connector Post by LANCER on 01/15/10 at 15:34:10 Quick question about connectors. I picked up a throttle assembly from an '05-later model bike and the connector has more pins than my '96; I am assuming that it is for the added feature of the emergency blinkers. Question is, is this just a matter of removing a pin or are there other wiring changes that would be needed ? |
Title: Re: Electrical connector Post by justin_o_guy2 on 01/15/10 at 16:46:10 Can you look at the bike end of the connector & compare to the throttle end & see if a couple of pins go to blank spots on the bike end? If so, maybe you can just plug it in & not worry about it? Orr,, use an Ohm meter & see where the connector wires run now? |
Title: Re: Electrical connector Post by Yonuh Adisi on 01/15/10 at 17:35:21 Does the connector you are referring too, look like this? This is on my 2000 wiring harness. I traced this connector to the harness that goes to the turn sigs and high beam switches. http://c3.ac-images.myspacecdn.com/images02/125/l_ea9d9c1349f74693b615c872234f696a.jpg Bobbert and I just went through this comparing my 2000 harness to his '96. His does not have this plug while mine does. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |