SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> New mod /cgi-bin/YaBB.pl?num=1263433188 Message started by Yonuh Adisi on 01/13/10 at 17:39:48 |
Title: New mod Post by Yonuh Adisi on 01/13/10 at 17:39:48 Decided to relocate my speedo again and get rid of the coffee can housing I had been using. I had some sheet metal left over from my wind generator project (which is on hold at the moment) and used it to wrap around my speedometer. I used sheet metal screws to secure it and found a couple of handle bar clamps which I used to secure it to the handle bars. I must say it looks much better than what I did have. http://c2.ac-images.myspacecdn.com/images02/127/l_b535799575b04889b67af555dfc13319.jpg http://c2.ac-images.myspacecdn.com/images02/149/l_cbb1d09d39394338a9f585316e87e309.jpg |
Title: Re: New mod Post by mumbles on 01/14/10 at 05:24:02 I think the speedo should always be mounted on the handlebar just for better site. Looks good and different. How much longer speedometer cable did it take? |
Title: Re: New mod Post by Yonuh Adisi on 01/14/10 at 11:35:24 The tach cable from a mid eighties Suzuki GT750 is a direct swap but just an inch or two longer. That's what I used. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |