SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Blinker problems?
/cgi-bin/YaBB.pl?num=1259684755
Message started by matt_savage on 12/01/09 at 08:25:55

Title: Blinker problems?
Post by matt_savage on 12/01/09 at 08:25:55
So I noticed my rear right blinker was out and I replaced the bulb.  Now the left front and rear blinkers work normal while the right rear will not come on and the front right one blinks much faster than the left one?  What gives?  All the wires under the seat leading to the rear blinkers are wired and hooked up correct.  Why does the front right one blink faster and the right rear one not come on?  TIA

-Matt

Title: Re: Blinker problems?
Post by verslagen1 on 12/01/09 at 08:51:52
fast blink rate indicates low load or a burnt out blub.
check the bulb, check the connections.

Title: Re: Blinker problems?
Post by justin_o_guy2 on 12/01/09 at 09:00:05
You sure you put a 2 filament bulb in? 1157?

Title: Re: Blinker problems?
Post by matt_savage on 12/01/09 at 09:11:32
Pretty sure I put the correct bulb in but I'll look when I get home.  Also 99.9% sure all the wired connection are correct since I checked it a few weeks ago when I replaced the bulb.

-Matt

Title: Re: Blinker problems?
Post by verslagen1 on 12/01/09 at 11:30:27
You checked it?
Should be obvious then what the problem is.   ;D

Title: Re: Blinker problems?
Post by Serowbot on 12/01/09 at 11:51:12
Sounds like you replaced it with a dead bulb....

Title: Re: Blinker problems?
Post by thumperclone on 12/01/09 at 12:43:46

0B141215080F3E0E3E06141853610 wrote:
You sure you put a 2 filament bulb in? 1157?

right rear is 1156 single filiment

Title: Re: Blinker problems?
Post by matt_savage on 12/01/09 at 12:49:31
Both rear blinkers should be the single filament correct?  They only illumuinate when the blinker is activated so that means only one filament needs to glow correct?  And yes, both rears have the same single filament bulb and the left works and the right doesnt light up and the front blinks fast, hmmm?

-Matt

Title: Re: Blinker problems?
Post by EJID on 12/01/09 at 12:59:09
Try swapping left to right on the rear and see if it works...

Title: Re: Blinker problems?
Post by justin_o_guy2 on 12/01/09 at 13:19:59

3C3025250E223027303634510 wrote:
Both rear blinkers should be the single filament correct?  They only illumuinate when the blinker is activated so that means only one filament needs to glow correct?  And yes, both rears have the same single filament bulb and the left works and the right doesnt light up and the front blinks fast, hmmm?

-Matt




DOOOOH! What wuz I Theeenkeeeng?

SuzukiSavage.com » Powered by YaBB 2.2!
YaBB © 2000-2007. All Rights Reserved.