SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Rear turn signal replacement /cgi-bin/YaBB.pl?num=1254893804 Message started by JustPassinThru on 10/06/09 at 22:36:43 |
Title: Rear turn signal replacement Post by JustPassinThru on 10/06/09 at 22:36:43 I dropped it. Getting it off a trailer, loosening the tie-down straps, one unhooked - and over it went. Not much damage - the saddle landed on the trailer fender - but the left turn signal on the rear broke off like a wishbone. Now's the time to move those signals - make room for saddlebags. What I had in mind, was a set of truck-type LED one-face amber pedestal-mount signals; to mount either under the taillight or on the fenders, at the rear. But those are hard to get, and spendy - about $30 EACH, a sixty-dollar cost. Using conventional round truck signals with incandescent bulbs would look cheesy. Anyone have a better solution? Aftermarket turn signals; or a readily-available type off another breed? |
Title: Re: Rear turn signal replacement Post by qp on 10/06/09 at 23:00:34 Not always inexpensive, but you might try customdynamics.com, they specialize in LEDs for cycles. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |