SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Turn signal wiring
/cgi-bin/YaBB.pl?num=1251070000

Message started by Mattdw on 08/23/09 at 16:26:40

Title: Turn signal wiring
Post by Mattdw on 08/23/09 at 16:26:40

Can I expect that if I remove the rear turn signals that the front turn signals flash twice as fast?


Title: Re: Turn signal wiring
Post by verslagen1 on 08/23/09 at 16:28:11

probably

Title: Re: Turn signal wiring
Post by Demin on 08/23/09 at 16:43:54

They wont flash at all.

Title: Re: Turn signal wiring
Post by Savage_Amusement on 08/23/09 at 19:26:58

I know the rear ones flash with out the front ones, so it might work the other way around.

Title: Re: Turn signal wiring
Post by matt_savage on 08/23/09 at 20:22:05

Removing the rear ones has no effect on the front ones.  I removed my rears for a time (VA doesnt reguire turn signals-hand signals are enough) and my front ones still flashed the same as normal.  Now I'm tracking down a wiring issue that has taken away my right rear signal and rear brake light??  Any ideas??

Title: Re: Turn signal wiring
Post by PTRider on 08/23/09 at 20:22:28

Yep, disconnecting the rears makes the flasher act just like a burned out bulb with rapid flashing.

Title: Re: Turn signal wiring
Post by Savage_Amusement on 08/23/09 at 23:48:34


383421210A263423343230550 wrote:
Removing the rear ones has no effect on the front ones.  I removed my rears for a time (VA doesnt reguire turn signals-hand signals are enough) and my front ones still flashed the same as normal.  Now I'm tracking down a wiring issue that has taken away my right rear signal and rear brake light??  Any ideas??



Ground, or one of the wires under the seat. Also possible that both bulbs blew one of the two elements in them.

SuzukiSavage.com » Powered by YaBB 2.2!
YaBB © 2000-2007. All Rights Reserved.