|
SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Idle Mixture screw /cgi-bin/YaBB.pl?num=1249510061 Message started by jsw1159 on 08/05/09 at 15:07:41 |
|
Title: Idle Mixture screw Post by jsw1159 on 08/05/09 at 15:07:41 I had drilled out the brass plug and set my carb after re-jet but now my mixture screw wants to back out after riding for awhile. Is there anything I can use to keep this from happening or just keep adjusting? Anyone have any suggestions |
|
Title: Re: Idle Mixture screw Post by voldigicam on 08/05/09 at 16:40:31 Teflon tape. |
|
Title: Re: Idle Mixture screw Post by verslagen1 on 08/05/09 at 16:58:43 If it's more than 3 turns out, you should go up to the next jet size. And if it's more than 3 turns out, it's likely to back out on its own. |
|
Title: Re: Idle Mixture screw Post by jsw1159 on 08/05/09 at 19:34:37 I,m only 2 turns out on the screw, but when i ride it ends up back out to 3, 31/2 turns and starts to run bad until i re-adjust |
|
Title: Re: Idle Mixture screw Post by verslagen1 on 08/05/09 at 19:41:10 There's supposed to be a spring and / or oring in there |
|
Title: Re: Idle Mixture screw Post by justin_o_guy2 on 08/05/09 at 19:49:42 If you lost yours, dont panic, try swiping one out of a pen. I havent tried it, may not be wide enough, but Id go look that way if I was in trouble |
|
Title: Re: Idle Mixture screw Post by jsw1159 on 08/05/09 at 19:51:54 If there suppose to be a spring or o-ring then it should be in there because i never took the screw completely out and it was new and stock when i bought the bike. |
|
Title: Re: Idle Mixture screw Post by justin_o_guy2 on 08/05/09 at 19:53:57 Oh, I thot you mangled your & had to put a new one in. Guess youd better pull it & see whats goin on in there. EDIT* I went & looked. It was 4 carb corvair,, sorry. |
|
Title: Re: Idle Mixture screw Post by LANCER on 08/06/09 at 00:36:39 The adjusting screw should have a spring, tiny washer, and o-ring. If you are not careful when removing the screw, one or all of those parts can drop off and hide forever from you. Also, if you are missing one or more of them, check inside the hole for the screw; the o-ring especially can easily get lodged down inside there and if you do not notice it being missing, then when you insert the screw back in the hole and screw it down, the o-ring gets mangles all to pieces. :( |
|
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |