SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Pilot Jet Question /cgi-bin/YaBB.pl?num=1247843391 Message started by DrunkenDwarf on 07/17/09 at 08:09:51 |
Title: Pilot Jet Question Post by DrunkenDwarf on 07/17/09 at 08:09:51 Has anyone done any testing to come up with some sort of equivalence between pilot jet size and screw turns? For example: 52.5 @ 3 turns "is equivalent to" 52.5 w/ bleed holes @ 1 turns 52.5 w/ bleed holes @ 3 turns "is equivalent to" 55 @ 1 turn Or is there no overlap? For example: 52.5 @ 3.5 turns "is leaner than" 52.5 w/ bleed holes @ 0.5 turn 52.5 w/ bleed holes @ 3.5 turns "is leaner than" 55 @ 0.5 turn -D. Dwarf |
Title: Re: Pilot Jet Question Post by DrunkenDwarf on 08/11/09 at 07:18:33 Bump once for feedback. Diamond Jim has come the closest to documenting this with his Progressive Jetting Guide (http://suzukisavage.com/cgi-bin/YaBB.pl?num=1244217127). One additional question. I know there's a "maximum" number of recommended pilot mixture screw turns out (around 3). Is there a "minimum"? Thanks. -D. Dwarf |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |