SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Size of exhuast bolt?
/cgi-bin/YaBB.pl?num=1246596829

Message started by ineclipse on 07/02/09 at 21:53:49

Title: Size of exhuast bolt?
Post by ineclipse on 07/02/09 at 21:53:49

Anyone know this off the top of their heads? I have to re-tap mine tomorrow to clean up some less than perfect threads, wanted to know the bolt size. If I havent heard anything by the afternoon I can certainly just swing by a homedept and use their bolt sizeing dohicky on the way to pick up a tap set.
Thanks ya'll,
-Luke.

Title: Re: Size of exhuast bolt?
Post by BurnPgh on 07/02/09 at 23:07:53

WTF happened now!? If you're talking about the bolts that connect the header to the cylinder its 8mm by 35mm with 10mm head. Not sure of the pitch. If thats not what you're talking about give me a call and I'll go check whatever you need. Come home soon brother. I miss you. And Elaina. Bring her back too i geuss. Kidding...kidding. I miss you both. Get your asses back here.

Title: Re: Size of exhuast bolt?
Post by ineclipse on 07/03/09 at 15:56:22

No, the bolts that connect the exhaust pipe to the manifold. Think they are 8mm by 1.25. I think. I stripped them, I think by contacting the ground too many times with the now lowest hanging point on the bike, the over sized exhaust clamp that helped out resolving the leak. Anyhoo. there is no leak using only one bolt, which ist just crazy to me, but I want to try to re tap it for sense of security.
I should just have called you, huh?

Title: Re: Size of exhuast bolt?
Post by BurnPgh on 07/03/09 at 22:40:10

yea...that bell sucks. and I think we're talking about the same bolts.