SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> mixture screw /cgi-bin/YaBB.pl?num=1246246376 Message started by GrateFuLDad on 06/28/09 at 20:32:56 |
Title: mixture screw Post by GrateFuLDad on 06/28/09 at 20:32:56 my mixture screw is boogered up and i cant turn it to adjust it ... any ideas on getting this out.. i did use a small tiny drill bit to go back and forth and back and forth real easy in flathead groove to try to get some sort of (cut) space there to adjust/remove it but wondering if there is any other way to get this out...? i am just going to replace it with another one... i think whoever owned the bike before me when they took brass plug out must of messed this up? |
Title: Re: mixture screw Post by serowbot on 06/28/09 at 22:13:38 Reverse drill bit, or easy out,... use a variable speed drill going very slow with good pressure, when the edge catches lighten pressure and let the bit back it out. or,... if you're really cheap like me,.. get a small, sharp edge phillips, give it a light, sharp wrap with a hammer, to embed the tip into the brass, then back it on out. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |