|
SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> top end... /cgi-bin/YaBB.pl?num=1242761323 Message started by 1988savage on 05/19/09 at 12:28:43 |
|
Title: top end... Post by 1988savage on 05/19/09 at 12:28:43 i got my engine fully off the frame... now to get the top end of the cylinder off? i cannot seem to get the part of the cylnder off where the head gasket is.... any ideas? |
|
Title: Re: top end... Post by PipJones on 05/19/09 at 14:01:41 Drink more |
|
Title: Re: top end... Post by serowbot on 05/19/09 at 14:08:24 0930291336373C2A590 wrote:
and after that,... if you're sure you've got all the bolts out,... give a gentle twist with a flat-blade screwdriver between the fins... it's just the sealant gluing it down... if that don't work,... drink a lot more and try it again.... :-? |
|
Title: Re: top end... Post by Yonuh Adisi on 05/19/09 at 16:21:00 Check fore and aft of the outside of the head, there are two 12mm nuts that have to be removed as well as the four 14 mm nuts on the top with one under the infamous plug. |
|
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |