SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Brake Fluid question /cgi-bin/YaBB.pl?num=1242374165 Message started by Jay on 05/15/09 at 00:56:05 |
Title: Brake Fluid question Post by Jay on 05/15/09 at 00:56:05 Just changed out the brake fluid, and as I was securing the lid on the resevoir I noticed that stamped on the lid it said "use only DOT #4 fluid"; well I had just exchanged all the fluid and used #3. Is there that much of a difference? I'd hate to have to go out to Wally-world at this hour just to buy brake fluid; but if I gotta, I gotta. Thanks. |
Title: Re: Brake Fluid question Post by Jay on 05/15/09 at 03:21:59 OK, nevermind. Consulted the Clymer's. It says DOT 3 or 4. Shoulda looked there first. Sorry. :-[ |
Title: Re: Brake Fluid question Post by Savage Eddie on 05/15/09 at 14:53:15 sorry, late on this post.... Dot 3 has a boiling point around 400 degrees Dot 4 has a higher boiling point, 446 degrees. As the good ol Clymer said, you can use either one. the chemical make up is very similar. |
Title: Re: Brake Fluid question Post by Jay on 05/15/09 at 23:20:22 Thanks Savage Eddie. I hope the fluid won't get over 400 degrees. Vaporization would not be cool. (No pun intended.) I wonder what the average, normal operating temp of the brake fluid is? |
Title: Re: Brake Fluid question Post by JohnBoy on 05/16/09 at 10:14:11 [edit]I wonder what the average, normal operating temp of the brake fluid is?[/edit] Going up the mountain, or coming down? |
Title: Re: Brake Fluid question Post by aliassmith on 05/16/09 at 10:20:38 OH No! Now the world as we know it is about to end! Aliassmith |
Title: Re: Brake Fluid question Post by Jay on 05/16/09 at 20:05:18 4C696E6844697F060 wrote:
;D ;D ;D ;D |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |