SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> problem with cyclinder head nuts /cgi-bin/YaBB.pl?num=1240798079 Message started by DocNeedles on 04/26/09 at 19:07:59 |
Title: problem with cyclinder head nuts Post by DocNeedles on 04/26/09 at 19:07:59 The Suzuki Manual on page 2-4 refers to the cylinder head nuts as being 9 mm and 8 mm. Mine are 14 mm and 12 mm. It is a 1986 any suggestions on why the difference? Thanks. DocNeedles |
Title: Re: problem with cyclinder head nuts Post by Charon on 04/26/09 at 19:12:04 The size referred to in the books is the size (diameter) of the bolt itself, not the size wrench needed to turn it. The wrench size is bigger. |
Title: Re: problem with cyclinder head nuts Post by Yonuh Adisi on 04/26/09 at 19:46:23 68434F6249494840495F2C0 wrote:
That threw me also until the guys here explained it to me. |
Title: Re: problem with cyclinder head nuts Post by DocNeedles on 04/26/09 at 21:13:39 0A21283B2627490 wrote:
Hey, Thanks for this, I thought I was going crazy. DocNeedles |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |