SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> CARB with 4 ports???
/cgi-bin/YaBB.pl?num=1240446608

Message started by Chief Gunner on 04/22/09 at 17:30:08

Title: CARB with 4 ports???
Post by Chief Gunner on 04/22/09 at 17:30:08

I have an 87 savage, not sure what is original and what has been swapped out. I looked all over the carb for model number as described on this forum and in the Clymer manual and found none.
Anyway it has 4 ports, the petcock has only 2. The main supply is obvious as is the vacuum port. The other two are located midway up on both sides and if I leave the petcock on PRI or RES gas will flow out of them after sitting with the engine off. I have to set to FUEL in order to keep it from happening. It has to be set for RES or PRI in order to run. Not sure what the difference between the two is, when I had the petcock out they both run to the same hole there is no separation inside the tank.
I would plug off the two 'extra' ports but I don't want it to flood the engine either.
Any suggestions???

Title: Re: CARB with 4 ports???
Post by verslagen1 on 04/22/09 at 17:44:27

since you're on line this will come in spurts... :o

http://suzukisavage.com/cgi-bin/YaBB.pl?num=1239680500

The all important table of contents...

http://suzukisavage.com/cgi-bin/YaBB.pl?num=1181745927

Title: Re: CARB with 4 ports???
Post by verslagen1 on 04/22/09 at 17:45:20

Everything you've always wanted to know...

http://suzukisavage.com/cgi-bin/YaBB.pl?num=1098869040

http://suzukisavage.com/cgi-bin/YaBB.pl?board=tech;action=display;num=1191899985

There's alot more, but you go find it I got wrenches to turn. ;D

Title: Re: CARB with 4 ports???
Post by Chief Gunner on 04/22/09 at 17:51:09

roger that bud thanks!!