SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Starter gear offset? Reassembly...pics included!!!
/cgi-bin/YaBB.pl?num=1238822586

Message started by Morbius on 04/03/09 at 22:23:06

Title: Starter gear offset? Reassembly...pics included!!!
Post by Morbius on 04/03/09 at 22:23:06

There are three gears on the starter idle limiter. Problem is they aren't lined up. Are they suppose to be? Is the other gear suppose to be angled?

http://lh3.ggpht.com/_F9VaGnhfM0s/SdXN797K3JI/AAAAAAAAAYo/oxltDwpCvnk/s800/PICT5954.JPG
http://lh4.ggpht.com/_F9VaGnhfM0s/Sdbori-P4BI/AAAAAAAAAZU/Iwa8y6GSX8Y/s800/PICT5964.JPG
http://lh3.ggpht.com/_F9VaGnhfM0s/SdbtsM1sy1I/AAAAAAAAAZ0/g6hwrJITNfQ/s800/PICT5965.JPG
http://lh4.ggpht.com/_F9VaGnhfM0s/SdbtDbbwmLI/AAAAAAAAAZs/1G2uV9KB7eQ/s640/Starter%20gears.gif

Title: Re: Starter gear offset? Reassembly...pics include
Post by verslagen1 on 04/03/09 at 23:40:56

You gotta push that idle gear in further

That gear with the 3 misaligned teeth is an anti back lash gear. Clymer doesn't give a clue how to align those teeth, but does say that gear goes on 2nd after the driven gear (big one). then the other gear.

I'd take the starter out for now.

Title: Re: Starter gear offset? Reassembly...pics include
Post by Morbius on 04/04/09 at 00:55:16

How would I get that gear to go down further? With the idler gears 3 teeth offset, the straight tooth gear cant slide past the first one. I did put them in the order the book says, I doesn't seem like it matters. Does anyone have a picture of this gear or know more about how these mesh togheter?

Title: Re: Starter gear offset? Reassembly...pics include
Post by Kropatchek on 04/04/09 at 09:14:08

The 3 gears are hold together by friction. Take a flat-nose punch and line-up the gears one-by-one.

Title: Re: Starter gear offset? Reassembly...pics include
Post by Morbius on 04/04/09 at 13:13:48

Thank you, that makes sense, just didn't want to break it.