SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> will these work?
/cgi-bin/YaBB.pl?num=1235864270

Message started by oksavage on 02/28/09 at 15:37:50

Title: will these work?
Post by oksavage on 02/28/09 at 15:37:50

http://www.kuryakyn.com/index.cfm/go/Home.ProductDetail/catID/0/scID/0/IMID/3739

will these fit a Savage???

cause they are sweeeettt!!!!

that whole Zombie line is badA$$

Title: Re: will these work?
Post by BigSingle on 02/28/09 at 18:29:18

cool site, just not sure what exactly you were refering too though couse the link just takes you to the home page...

Title: Re: will these work?
Post by verslagen1 on 02/28/09 at 19:06:46

All they need is them zombie eyeballs to light up as turn signals.

Title: Re: will these work?
Post by oksavage on 02/28/09 at 20:21:58

it says they are for all 08-09 Harleys, could I use these, is that a 1" bar?

Title: Re: will these work?
Post by serowbot on 02/28/09 at 20:32:51

27233B293E292F2D480 wrote:

it says they are for all 08-09 Harleys, could I use these, is that a 1" bar?

1"?..... Yup.... You're good to go... assume they're grips, can't tell from the link...... but make sure throttle side is bigger I.D. than clutch side.... I think some Harley's have same size, both sides.... that won't work...

Title: Re: will these work?
Post by Big Nix on 03/07/09 at 03:47:27

Those ought to work for yah, but let me tell yah I just recently rediscovered Ebay, had surgery on my foot so been laid up surfing the web alot, but all it takes is a little time and some looking and you can find alot of good deals. I just got a set of new Harley drag bars for $15, new skull grips for $13.00, and a set of used chrome foot pegs for $5 check it out before you drop all that money... of course if you're not on a tight buget like i am then it don't really matter.

Title: Re: will these work?
Post by oksavage on 03/07/09 at 06:53:54

the reason i'm confused is because the description talks about dual throttle cables and they are only listed in the Harley section on the Kuryakyn website, it makes me mad that they don't make all their products more universal, cause I see alot more metric cruisers leaving the showroom right now, but oh well, the guys on this forum have overcome harley prejudice in aftermarket parts with innovation 8-)

Title: Re: will these work?
Post by Tincanman on 03/07/09 at 11:34:01

any thing thats 1" should be fine. I have the FLAME grips & pegs on my bike. I had to shave off the RH side plastic ridges but its not hard. [smiley=beer.gif]

http://p1.bikepics.com/pics/2008/10/11/bikepics-1446188-800.jpg