SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Clutch cable and wiring loom Routing
/cgi-bin/YaBB.pl?num=1229719557

Message started by hudson on 12/19/08 at 12:45:57

Title: Clutch cable and wiring loom Routing
Post by hudson on 12/19/08 at 12:45:57

hi everyone, this might seem a strange question, but i am rebuilding my savage over the winter and it's been in bits for a while. i have forgotten how the clutch cable and the wiring loom runs down the forks and frame, can anyone add some pictures to help please. thanks

Title: Re: Clutch cable and wiring loom Routing
Post by Max_Morley on 12/19/08 at 13:29:38

If you have access to a factory manual it has a diagram of what you are looking for in the last chapter as I remember. If not PM me a direct e-mail and I send you a copy. Max

Title: Re: Clutch cable and wiring loom Routing
Post by LANCER on 12/20/08 at 04:29:04

You can run any wire or cable any way you wish; the only limitation is that it gets to where you need it to plug in. Whether you go up, down, left, right, or whatever just doesn't matter. If the assorted parts of the wiring harness are able to plug in to the parts needed then go for it...of course make sure that the routing avoids contacting the hot engine or exhaust, and possible damage from pinching under the tank, etc. Other than that do as you will.