SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Painting the Motor ? /cgi-bin/YaBB.pl?num=1226506695 Message started by mikestrikes on 11/12/08 at 08:18:15 |
Title: Painting the Motor ? Post by mikestrikes on 11/12/08 at 08:18:15 When painting the Jug and Head how do you get the paint down in the fins without making the outside of the fins to thick and runny ? |
Title: Re: Painting the Motor ? Post by sakara on 11/12/08 at 08:23:20 tape the outside of the fins? thin strips I assume would do it. |
Title: Re: Painting the Motor ? Post by mikestrikes on 11/12/08 at 08:42:05 4F5D575D4E5D3C0 wrote:
I'll sand the very ends of the fins after it sets up. I was talking about it getting thick and runny out close to the edges while not being able to get enough deep down in the fins... |
Title: Re: Painting the Motor ? Post by serowbot on 11/12/08 at 09:24:06 I never worried about it when I did mine...came out fine. Keep coats thin, give a minute or two for paint to tack i bit before hitting again. Use heat paint,...I bought rattle can low gloss engine paint at Checker auto. |
Title: Re: Painting the Motor ? Post by sakara on 11/12/08 at 09:28:29 gotcha, I misunderstood; yeah, slow and thin, multiple applications will prevent build up and run off. |
Title: Re: Painting the Motor ? Post by justin_o_guy2 on 11/13/08 at 00:14:22 Lay engine on side, paint top edge? Let dry, lay on other side? But really, who is gonna be in a position to critique the area between the fins? Someone doesnt like it, tell em paint it.. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |