SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Jet Needle
/cgi-bin/YaBB.pl?num=1225494626

Message started by PipJones on 10/31/08 at 16:10:23

Title: Jet Needle
Post by PipJones on 10/31/08 at 16:10:23

where on earth can you get a plastic get needle spacer to allow the fuel mixture to richen? do i have to fabricate one? or can i use a metal spacer?

Pip Jones

Title: Re: Jet Needle
Post by bill67 on 10/31/08 at 16:13:59

Get metal washers the same size I don,t know the size its in here somewhere

Title: Re: Jet Needle
Post by PipJones on 10/31/08 at 16:15:49

thanks for the quick post. i get to rebuld my carb tomorrow, install a new airfilter (my bike has been ridden at least 3000 miles without one), install new rubber duct from airbox to carb, install new crank case gasket (fixed my neutral light sensor) and fire her up!!!!!! i'm super excited.

fantastic weekend here in texas, can't wait to get back on the road!!!!

Pip Jones

Title: Re: Jet Needle
Post by dasch on 11/01/08 at 03:57:15

Lancer says washers are 6mm OD, 0.5mm thick. Original plastic washer is 3mm thick. Thinner washer - richer mix.
Fabricate, improvize, aluminum would do too, if you can fabricate it somewhere.

Title: Re: Jet Needle
Post by verslagen1 on 11/01/08 at 08:59:34

they've said #4 washers, but I think it's smaller

Title: Re: Jet Needle
Post by serowbot on 11/01/08 at 10:24:04

I used a nylon #4 washer from Ace hardware...measures 1/3 thickness of original. They come in black or white. both the same.