SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Stock header pipe. /cgi-bin/YaBB.pl?num=1222379361 Message started by mikestrikes on 09/25/08 at 14:49:20 |
Title: Stock header pipe. Post by mikestrikes on 09/25/08 at 14:49:20 I know most stock pipes are double walled. I want to know the inside dia of the stock pipe so I can go ahead and pick up some SS tube a little bigger to make a new one. |
Title: Re: Stock header pipe. Post by KwakNut on 09/25/08 at 15:42:02 Stock pipe ID is about 1¼", but that's way too small. Some aftermarket pipes are up to 50mm ID, but that's a little too big unless you're wanting to go for a really wild tune and overbore. Keeping to 650cc and not wanting to rev much higher, but porting, sorting cam and carb, a 1¾" header would be about ideal. Anything from 40-45mm would be ok. |
Title: Re: Stock header pipe. Post by mikestrikes on 09/25/08 at 17:44:48 Well I got an old SS Muzzys header from a Kawasaki thats 1.425" inner dia, that for about half way then step up to 2" should work then.. Looks like I wont need to mess with the intake hardly at all, but that exhaust has alot of work needed.. that and bump the comp up a point or so .... Thanks this helps alot.. |
Title: Re: Stock header pipe. Post by LANCER on 09/25/08 at 19:18:16 I used 1.75" OD pipe, with 1.6" ID. This was with a performance cam and performance carb kit + a great muffler. With those basic mod's this pipe works great. I had intended to try a 1.5" ID with transition to 1.6" ID and then 1.75" ID before the muffler, but have yet to get it down. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |