SuzukiSavage.com /cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Front Pulley /cgi-bin/YaBB.pl?num=1221770642 Message started by vtail on 09/18/08 at 13:44:01

Title: Front Pulley Post by vtail on 09/18/08 at 13:44:01 Front pulley was slightly loose at 8400 miles. Heard a clicking noise when turning the rear wheel with the bike on my homemade lift. Tightened it 30 degrees. I would check this every time you change your rear tire (5-6K miles). torque 74-86 ft/lb. ;)

Title: Re: Front Pulley Post by Rogue_Cheddar on 09/19/08 at 18:43:43 You don't mention it so I have to ask. Did you remember to bend a couple of tabs of the lock washer over the nut?

Title: Re: Front Pulley Post by T Mack 1 on 09/19/08 at 18:50:34 383A2F27224E0 wrote: Front pulley was slightly loose at 8400 miles. Heard a clicking noise when turning the rear wheel with the bike on my homemade lift. Tightened it 30 degrees. I would check this every time you change your rear tire (5-6K miles). torque 74-86 ft/lb. ;) My sprocket was bad when I got the bike last year.  Thank goodness Savage Greg converted to chain.  I bought his old one.

Title: Re: Front Pulley Post by rigidchop on 09/20/08 at 13:59:58 i could barely get mine off, guess i'm lucky or am i?

Title: Re: Front Pulley Post by vtail on 09/20/08 at 16:02:51 142921332319052E2322222734460 wrote: You don't mention it so I have to ask. Did you remember to bend a couple of tabs of the lock washer over the nut? Ohhhh Yehh. Bend one over. you can always inspect it thru the slits ;)

SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved.