SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Cam Chain ? /cgi-bin/YaBB.pl?num=1220655341 Message started by eanon on 09/05/08 at 15:55:41 |
Title: Cam Chain ? Post by eanon on 09/05/08 at 15:55:41 We all know about the horrors of a loose cam chain, but what about to tight? Is that even possible? A welder buddy of mine did the extra hole mod on the tensioner for me, but reassembly was tight. I mean really tight. The tensioner is all the way in. And still pushing. I think he might have put the second hole a little to far away from the first (made the mod to long). :-? |
Title: Re: Cam Chain ? Post by Oldfeller on 09/05/08 at 16:04:14 Don't wish to be scary, but consider your cam bearings (the ones that are cut raw into the head material) what are they doing under that one sided constant load .... |
Title: Re: Cam Chain ? Post by verslagen1 on 09/05/08 at 23:56:56 what was the offset? |
Title: Re: Cam Chain ? Post by eanon on 09/06/08 at 09:59:13 Don't remember. I'm thinking I'll just pull the tensioner out later today and grind the hole a little. I can measure it then. |
Title: Re: Cam Chain ? Post by verslagen1 on 09/06/08 at 10:09:23 18mm (.708") is the distance I'd recommend. 3/4 is too far, 5/8 is fine I bet you got 3/4 |
Title: Re: Cam Chain ? Post by eanon on 09/06/08 at 16:02:34 I'm looking at 13/16ths. (as close as I can tell). So, yup, I'm too tight. Bike is gonna be down for a few days, (see new thread) so I'll see if I can't get it sorted. Thanks for the info verslagen. |
Title: Re: Cam Chain ? Post by verslagen1 on 09/06/08 at 16:25:49 cut it off and have your welder buddy put another on. |
Title: Re: Cam Chain ? Post by Kropatchek on 09/07/08 at 08:34:12 Initial installation with verslavy or other mods: the tensioner should be 2 klicks ( of the ratched) out. ( from the recommendation of Norbert the German camchain guru) :P |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |