SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Mikuni VM carb
/cgi-bin/YaBB.pl?num=1219455474

Message started by louie650 on 08/22/08 at 18:37:54

Title: Mikuni VM carb
Post by louie650 on 08/22/08 at 18:37:54

Does anybody know how to disconnect the throttle cable from a Mikuni VM carb?  I have read the posts on the stock carb but the Mikuni is not the same.

Title: Re: Mikuni VM carb
Post by LANCER on 08/22/08 at 19:07:16

Unscrew the cap on top of the carb, pull out the slide and you will see the cable attached to the inside bottom of the slide.  There should be a little plate sitting in the bottom of the slide which will fall out if you turn the slide upside down.  Now slide the end of the cable to the other end of the little slot and the cable will come out.  Then pull it out through the middle of the top of the carb cap.

http://images1.snapfish.com/232323232%7Ffp335%3Enu%3D323%3A%3E639%3E697%3EWSNRCG%3D3233554%3A%3B2926nu0mrj

http://images1.snapfish.com/232323232%7Ffp338%3Enu%3D323%3A%3E639%3E697%3EWSNRCG%3D3233554%3A%3B2933nu0mrj

http://images1.snapfish.com/232323232%7Ffp335%3Enu%3D323%3A%3E639%3E697%3EWSNRCG%3D3233554%3A%3B832%3Anu0mrj

http://images1.snapfish.com/232323232%7Ffp335%3Enu%3D323%3A%3E639%3E697%3EWSNRCG%3D3233554%3A%3B8335nu0mrj

http://images1.snapfish.com/232323232%7Ffp335%3Enu%3D323%3A%3E639%3E697%3EWSNRCG%3D3233554%3A%3B8344nu0mrj

http://images1.snapfish.com/232323232%7Ffp335%3Enu%3D323%3A%3E639%3E697%3EWSNRCG%3D3233554%3A%3B834%3Cnu0mrj


Title: Re: Mikuni VM carb
Post by thumperclone on 08/23/08 at 07:19:35

GREAT photos!!!

SuzukiSavage.com » Powered by YaBB 2.2!
YaBB © 2000-2007. All Rights Reserved.