SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> White spacer mod tip /cgi-bin/YaBB.pl?num=1219121009 Message started by moto fugazzi on 08/18/08 at 21:43:28 |
Title: White spacer mod tip Post by moto fugazzi on 08/18/08 at 21:43:28 Well, I did the white spacer mod last weekend with Lancer's kit. Anyhoo, I thought I would pass along my little tip for removing the 4 screws off of the top of the carb. I took off the carb and paced it on a couple pieces of wood (one on each side so that the drain tube wouldn't break). I used a #2 screw driver. I pushed down hard and tapped the top of the screwdriver with a hammer while trying to loosen the screws. After a few taps, the screws gave way very easily. This effect is much like a impact driver: http://www.sears.com/shc/s/p_10153_12605_00947641000P?vName=Automotive&cName=Tools&Equipment&sName=Automotive%20Specialty%20Tools&psid=FROOGLE01&sid=IDx20070921x00003a Hopefully, this will save some frustration for others. Also, buy a nice screwdriver-those 50 cent ones will strip out something. It's not like you would never use it again. Saving $4 on a junk screwdriver will cause you extra work and tools to remove the stripped out screws. Hope this helps, Ken |
Title: Re: White spacer mod tip Post by Digger on 08/19/08 at 22:10:11 Thanks for the tips! I'm not sure, but those screws may be JIS Phillips screws. If so, they'll have a small dot embossed into the head of the screw, by the cross. You can get JIS Phillips screwdrivers here: Ames (http://www.amessupply.com/products1.cfm?aid=1&cid=D&sid=DE&fid=1404070), among other places. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |