SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Need some help! /cgi-bin/YaBB.pl?num=1218727484 Message started by nparker on 08/14/08 at 08:24:44 |
Title: Need some help! Post by nparker on 08/14/08 at 08:24:44 Hello all, I just upgraded my wife's '05 with the jetset from Lancer and don't know if everything is set properly. The bike has a Jardine pipe and the stock airbox/filter. I've currently have a 150 main and drilled pilot jet installed. I have removed the white spacer and installed (2) #4 washers. My mixture screw is turned approximatley 3/4 to 1 turn out to have a smooth idle. When riding at a steady pace, the bike feels like it's surging and doesn't have much power. When I get off the throttle, I still get a backfire, not like before, but a backfire just the same. And sometimes when I get off the throttle, the bike shuts off (dies). I went through all the tips on setting up the carb and adjusting the mixture, but this is getting furstrating! >:( Any of you gurus out there care to lend a hand? |
Title: Re: Need some help! Post by Reelthing on 08/14/08 at 08:59:37 drilled pilot jet - you mean the one w/the emulsion holes (what size pilot jet?) or one that has been drilled out to a larger size? |
Title: Re: Need some help! Post by verslagen1 on 08/14/08 at 09:01:42 surging and lack of accel usually is white spacer, take out another washer. smooth idle with still a pop... on shut down? I'd richen that up a bit 1/8" turn. |
Title: Re: Need some help! Post by nparker on 08/14/08 at 16:23:30 7C4B4B425A464740492E0 wrote:
Yes, the one with the emulsion holes. No pop on shut down, only when I let off the gas in any gear. |
Title: Re: Need some help! Post by verslagen1 on 08/14/08 at 19:13:36 4F5140534A4453210 wrote:
some pop is ok just as long as it don't go kerpow! check the header bolts and muff clamp. air leaks will cause a pop. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |